How to Install AR Maglock Gen 2
Installing an AR Maglock Gen 2 is a task that requires attention to detail and a bit of mechanical know-how. Whether you’re looking to add a layer of security to your firearm or simply want to enhance its functionality, this guide will walk you through the process step by step.
Tools and Materials Needed
Before you begin, gather the following tools and materials:
- AR Maglock Gen 2 kit
- AR-15 rifle
- Hex wrench set
- Allen wrench
- Gunsmithing vise
- Clamp
- Gun cleaning solvent
- Compressed air
- Gun oil
Preparation
Ensure that your AR-15 rifle is unloaded and the magazine is removed. Place the rifle in a gunsmithing vise, securing it with a clamp. This will prevent any movement during the installation process.
Step 1: Removing the Existing Firing Pin Retainer
Using a hex wrench, remove the firing pin retainer pin from the upper receiver. This will allow you to remove the firing pin retainer and the firing pin.
| Tool | Function |
|---|---|
| Hex wrench | Removes the firing pin retainer pin |
| Allen wrench | Removes the firing pin retainer |
Step 2: Installing the Firing Pin
Insert the new firing pin into the upper receiver. Ensure that the firing pin is properly seated and that the firing pin retainer pin is in place. Tighten the pin with the hex wrench.
Step 3: Installing the Firing Pin Retainer
Slide the firing pin retainer over the firing pin and secure it with the Allen wrench. Make sure that the retainer is tight and that the firing pin is properly seated.
Step 4: Installing the Maglock Gen 2
Remove the Maglock Gen 2 from its packaging and inspect it for any damage or defects. Place the Maglock Gen 2 into the upper receiver, ensuring that it is properly aligned with the magazine well.
Step 5: Securing the Maglock Gen 2
Using the provided screws, secure the Maglock Gen 2 to the upper receiver. Tighten the screws with the Allen wrench, ensuring that the Maglock Gen 2 is securely attached.
Step 6: Testing the Maglock Gen 2
With the Maglock Gen 2 installed, load your AR-15 rifle with a magazine. Attempt to insert the magazine into the rifle. The Maglock Gen 2 should engage and hold the magazine in place. If it does not, double-check the installation and make any necessary adjustments.
Step 7: Final Inspection and Maintenance
Inspect the entire installation, including the firing pin, Maglock Gen 2, and upper receiver. Clean any dirt or debris from the components using gun cleaning solvent and compressed air. Apply a small amount of gun oil to the firing pin and Maglock Gen 2 to ensure smooth operation.
By following these steps, you should now have a fully functional AR Maglock Gen 2 installed on your AR-15 rifle. Remember to practice safe firearm handling and always keep your firearm unloaded when not in use.
