How to Remove Magpul Stock from AR-15
Removing the Magpul stock from your AR-15 is a task that many firearm enthusiasts encounter. Whether you’re looking to replace it with a different stock or simply need to clean it, this guide will walk you through the process step by step.
Tools and Materials Needed
Before you begin, gather the following tools and materials:
- AR-15 cleaning kit
- Hex wrench set
- Socket set
- Replacement stock (if applicable)
Step 1: Safety First
Always ensure your firearm is unloaded and the magazine is removed before attempting any maintenance or disassembly. Point the firearm in a safe direction and keep your finger off the trigger.
Step 2: Loosen the Stock Mounting Screws
Locate the two stock mounting screws on the upper receiver. These screws are typically located on the left side of the receiver, just above the magazine well. Use a hex wrench to loosen them, but do not remove them completely yet.
Step 3: Remove the Stock Mounting Screws
Once the screws are loose, use a socket set to remove them completely. Set the screws aside for now.
Step 4: Detach the Stock from the Receiver
With the screws removed, gently pull the stock away from the receiver. The stock should come off relatively easily, but if it’s tight, you may need to use a rubber mallet to gently tap it free.
Step 5: Inspect the Receiver and Stock
Before reassembling, inspect both the receiver and the stock for any signs of wear or damage. Clean any dirt or debris from the mating surfaces using a soft cloth and cleaning solvent.
Step 6: Reinstall the Stock (If Necessary)
If you’re replacing the stock, now is the time to do so. Simply reverse the steps above to install the new stock. Make sure the stock is securely attached to the receiver and that the mounting screws are tight.
Step 7: Reinstall the Stock Mounting Screws
Place the stock mounting screws back into their original holes on the receiver. Use a hex wrench to tighten them, but be careful not to overtighten them.
Step 8: Test the Stock
After the stock is reinstalled, test it to ensure it’s functioning properly. Cycle the action to make sure the bolt moves smoothly and that the stock is securely attached to the receiver.
Step 9: Clean and Lubricate
Once you’re satisfied with the stock’s installation, clean and lubricate the firearm as per the manufacturer’s recommendations. This will help ensure smooth operation and extend the life of your firearm.
Step 10: Store Your Firearm Properly
After completing your maintenance, store your firearm in a safe and secure location. Always follow local laws and regulations regarding firearm storage.
By following these steps, you should be able to successfully remove and reinstall the Magpul stock on your AR-15. Remember to always prioritize safety and consult the manufacturer’s instructions for specific details regarding your firearm.
